36
H5_30_Wide_HT_Roll_Up
Revision date: 06.28.19
Install Roll-Up Side Components
TWIST-OF-THE-WRIST ASSEMBLY (continued)
14. Measure 1/2" in from end of roll-up conduit, center-punch location on pipe, and drill a 5/16" hole through conduit.
15. Insert a tubing adapter into conduit and align holes of adapter with drilled holes in conduit.
16. Attach roll-up conduit to square shaft of assembly by inserting a 1/4" x 2" bolt (FAH005B) through hole in conduit
and tubing adapter. Secure using two 1/4" (FALB01B) nuts.
1/2"
Step 15: Align holes.
Step 16
17. Test operation of Twist-of-the-Wrist assembly. Adjust
components as needed.
18. Install all remaining assemblies for roll-up sides.
19. Once assemblies are installed and tested, continue
with installation of anti-billow ropes.
ATTENTION:
If conditions are windy, install anti-
billow ropes immediately after connecting the roll-up
conduit to Twist-of-the-Wrist assembly.
DO NOT ALLOW PANEL TO HANG FREELY FROM
SIDEWALL. TAKE THE NECESSARY STEPS TO
TEMPORARILY SECURE UNTIL ANTI-BILLOW
ROPES ARE INSTALLED.
End Panel
Installed