20
H5_30_Wide_HT_Roll_Up
Revision date: 06.28.19
ASSEMBLE AND ATTACH ROLL-UP DOOR CONDUIT
Complete these steps after installing end panels.
1. Use pipe diagram below and in Quick Start section to gather the
parts for the roll-up conduit assembly.
2. Assemble as shown in graphics.
3. Secure each connection using a Tek screw.
4. Insert pipe assembly into panel pocket (between the zippers) of the
door and position as desired.
5. Secure conduit to panel pocket using four (4) evenly spaced CC6212
fabric clips and Tek screws.
6. Open door zippers and test roll-up panel. Close door.
7. Repeat steps for remaining end panel roll-up door.
8. Continue with procedure on next page.
Attach Roll-Up Door Hardware
CC6212 Fabric Clip
Install clip.
Install Tek
screw.
Tape over screw if desired.
103396 Universal Joint
103395 Spin Handle
103396
131S075
131P072
Crank Up Assembly
103395
FA4482B Tek
Screw