21
Revision date: 06.28.19
H5_30_Wide_HT_Roll_Up
Baseboard Installation — Required
BASEBOARD INSTALLATION — REQUIRED
Gather the parts:
• 2" x 6" treated (if allowed) lumber (supplied by
customer).
• 1/4" x 4" Carriage Bolts (FAH009B), FAME50B (1/4")
flat washers, and FALB01B (1/4") nuts (included).
When properly installed, baseboard runs length of frame
at ground level.
Baseboard is supplied by customer.
The following procedure describes one way to install
baseboards. The size and type of baseboard may require
the use of alternative steps.
Outside the frame, attach first baseboard to rafter using
two (2) 1/4" carriage bolts and nuts. Continue adding
baseboards to complete first run.
Secure splices between posts as shown in drawing
below. Use a short section of baseboard to secure
separate baseboards at a splice. See diagram below.
Never attach ends of two separate boards to same
ground post. Always splice between rafters.
Repeat steps to attach a second run of baseboard to
remaining side of frame.
The above diagrams present examples only. Actual installation
depends on customer-supplied materials and other factors.
Inside of
Shelter
Ground
Level
1/4" Nuts &
Washers
Splice
1/4" Carriage
Bolts
Outside of
Shelter
Photo shows
the inside view
of a baseboard
splice.
Use a small
piece of wood
to secure a
splice.
Place on
backside/inside
of baseboard.
NOTE:
Boards should be at ground level or slightly into
grade to create a good seal between board and ground.
After installing baseboards, continue with these
instructions.
Interior
Rafter
Ground Level
Baseboard
Inside of
frame.
