![background image](http://html.mh-extra.com/html/gazelle/26800/26800_assembly-and-use-instructions_570559001.webp)
WARNING
________________________________________________
READ AND UNDERSTAND ALL ASSEMBLY, INSPECTION, & USE
INSTRUCTIONS PROVIDED BEFORE EACH USE. FAILURE TO FOLLOW
INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH.
NEVER ALLOW CHILDREN TO PLAY IN THIS PRODUCT UNATTENDED.
KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS TENT FABRIC.
THIS TENT IS MADE WITH FLAME RESISTANT FABRIC WHICH MEETS
CPAI-84 SPECIFICATIONS. IT IS NOT FIREPROOF. THE FABRIC WILL
BURN IF LEFT IN CONTINUOUS CONTACT WITH ANY FLAME SOURCE.
THE APPLICATION OFANY FOREIGN SUBSTANCE NOT THE TENT FABRIC
MAY RENDER THE FLAME RESISTANT PROPERTIES INEFFECTIVE.
THE USE OF ELECTRICAL DEVICES IS NOT RECOMMENDED INSIDE THE
GAZELLE CAMPING TENT.
CAMPING / LEISURE TENT
ASSEMBLY AND USE INSTRUCTIONS
SIDE WALL
2
SIDE
WALL
3
WHAT’S INCLUDED IN THE BAG
• Gazelle Camping / Leisure Tent
• Detachable rain fly
• Detachable floors • Detachable overhead gear lofts
• Ground Stakes • Tie-down ropes
BEFORE YOU BEGIN
• Locate a level site clear of all debris and sharp objects to prevent
tears while setting up your tent.
• For easy set-up in windy conditions, make sure to position a
narrow end of the tent into the wind, and stake down both
corners through the provided grommets.
• Do not set up your tent under any overhead obstructions in case
of falling objects or lightning strikes in inclement weather.
• The Gazelle 2-room camping tent can be set up and taken
down with the floors installed in the unit. It is recommended
that the rain fly, privacy panels, and gear lofts be taken down
before collapsing the tent.
SET-UP INSTRUCTIONS
1. Remove the camping tent from the carrying bag. Remove the
tie strap from around the unit.
[
SEE FIGURE 1 ]
2. Lay the tent flat on the ground and check that there is no material
twisted or overlapping the ends of any poles. DO NOT force shelter
when folding or unfolding. Watch for the entanglement of poles.
[ SEE FIGURE 2 ]
NOTE: For easy set-up in windy conditions, make sure to position
a narrow end of the tent into the wind, and stake down both
corners through the provided grommets.
3. Grasp the webbing loop sewn onto the eyelet located in the center
of one of the walls and pull outward until the wall pops open.
[ SEE FIGURE 3 ]
NOTE: For added assistance, grasp the top seam of the panel when
popping open a side wall panel to help hold the tent in place.
4. Proceed by walking around the entire tent, pulling out on each
webbing loop until all the side walls are popped out.
[ SEE FIGURE 4 ]
NOTE: At this time the rain fly can be assembled.
See INSTALLING THE RAIN FLY.
4
1