GRAUPNER MC-22S, Programming Manual

Page: 49 / 180

49
“Back-up all models PC”
m u s t a l l m o d e l s b e
s a v e d i n a f i l e o n P C ?
N O Y E S
In this case all occupied model memories are auto-
matically transferred to the PC in sequence for ba-
cking-up, in contrast to the “Copy mc22
external”
command.
Note:
If the transmitter battery voltage is too low, the trans-
mitter blocks all copy and erase functions in the inte-
rests of safety. The following message then appears
on the screen:
E r a s e m o d e l = >
C o p y m o d e l ® m o d e l = >
C o p y M X 2 2 ® e x t e r n a l = >
C o p y e x t e r n a l ® M X 2 2 = >
C o p y f l i g h t p h a s e = >
S e c u r e a l l m o d e l s ® P C = >
t
Not currently possible
Battery voltage too low
Suppress Codes
Suppressing Codes from the multi-function list
-ODELSELECT #OPY%RASE
"ASESETUPMODEL -ODELTYPE
3ERVOADJUSTMENT #ONTROLADJUST
$UAL2ATE%XPO
#HANNELCURVE
3WITCHDISPLAY #ONTROLSWITCH
3UPPRESS 4/'
In this menu you can suppress any functions in the
multi-function list which are not required for the cur-
rently active model, or which must not be changed.
For example, if you are programming different fl ight
phases, it is advisable to suppress all global settings
such as modulation, stick mode, servo settings etc..
The multi-function list can then be restricted to just a
few menus, and the function select list becomes ea-
sier to read. Suppressing the menus does not disable
those functions; it just means that they can no longer
be accessed directly.
Select the function to be suppressed using the rota-
ry control, then press the rotary control briefl y to sup-
press it, or re-activate it if already suppressed.
Tip:
If you do not wish to use a program block at all, we
recommend for safety’s sake that you remove the
»
Code lock « menu from the multi-function list using
the » Suppress codes « menu, otherwise it would be
relatively easy for an unauthorised person to enter a
secret code number, which would block your access
to the multi-function list.
Caution:
In the transmitter’s default state the expert mode is
set to “no” in the »
Basic settings « menu. This means
that some menu points are suppressed as standard.
If you wish to have all menu points available when
you call up a new model memory, you should fi rst set
this menu point to “yes”.
Exceptions: the » Fail-Safe « menu is only availab-
le when the transmitter is set to the “PCM20” or
“SPCM20” transmission mode; the » Swashplate mi-
xer « menu only appears if you set more than one
swashplate servo.
Program description: Model memories