GRASS VALLEY Kayenne XL Package, User Manual

Page: 500 / 624

500 Kayenne XL Package — User Manual
Section 5 — Menu Summaries
Aux Bus Control
• The
Used as
column shows AUX channels which are assigned for
external keyers (e.g. Video Send and Key Send to external DVE unit).
• Double click on the screen (touch or mouse) to set an Input to an Aux
Bus.
Aux Bus Transition
Note Please note, that Aux Transition is not available in 4.5 M/E configuration with
SD video standard.
• In the Trans Dur column the transition duration can be entered. Double
click on the cell to enter the value in frames.
• In the Trans Mode column the transition mode can be entered. Double
click on the cell calls a sub-dialog:
• Off : No Aux transition
• Direct Mode :

In Direct Mode pressing the low tally
Auto Trans
executes an AUX
transition with the known preset source. While this transition is
executed, the
Auto Trans
button light switched to high tally. When
this transition has reached the end, the Auto Trans button light
switched back to low tally and the mainframe swaps PGM and PST
sources. As a result, subsequent
Auto Trans button presses toggles
the transition in this mode.
• Auto Mode :

In Auto Mode the Direct Trans button is OFF and the Auto Trans
button is low tally. Pressing the Auto Trans button, it starts to flash.
If you push a source button at that AUX bus now, the preset source
will be newly preset and the AUX transition will be executed which
is indicated by the high-tally
Auto Trans
button while the transition
is running. At the end of the transition, PGM and PST swaps again
and the
Auto Trans button goes back to low tally. Doing this, you
have executed a single shot AUX transition by pushing an AUX
source button.

The Auto Mode can be used to decide during operation if the dedi-
cated AUX buses executes a CUT when pushing an AUX bus source
- or - executes an AUX transition if you preset this mode using the
flashing
Auto Trans button prologue.