GRASS VALLEY Kayenne XL Package, User Manual

Page: 368 / 624

368 Kayenne XL Package — User Manual
Section 5 — Menu Summaries
To configure the Misc parameters, select the parameter from the scroll list.
Then press
Modify to change the parameters.
•
Format
: Select an M/E specific TV format.
4:3
or
16:9
selection is pos-
sible in the respective M/E menu.
• Field Dominance : The button can be used to switch between
Any Field,
Field1
and
Field2
. The setting concerns the switching of the crosspoints
on all buses, the start of auto transitions, switching with Cut, and the
recalling of snapshots and timelines. In position
Any Field
, switching
occurs at the beginning of the next frame. In position
Field 1/2,
switching
or starting occurs before the corresponding field.
• Replace Async : The parameter permits the selection of different modes
for the treatment of asynchronous sources in the switching levels
(M/E1, M/E2, M/E3, PP, M/E-H):
• On : If Background/Program are asynchronous, enabled keyers are
disabled. If Background/Program are asynchronous and the fill
signal of a keyer becomes asynchronous, the enabled keyer is dis-
abled. If Background/Program or Preset are asynchronous and a
transition is selected, a cut is performed at the end of the transition.
•
Off
: Asynchronous signals are phased over H and are passed.
• Aux Preview Bus : Selecting the desired AUX Preview Bus None, Aux1 ...
Aux48.
•
Auto Aux Preview
: Enable or disable the Auto PVW mode. In enabled
condition the key PVW, mask PVW or the chroma key cursor signal of
the respective mixing level is switched on the PVW bus.
• Key Memory Auto Save : If the KeyMemo button is switched on in a
Keyers menu, the key memory is always recalled if the key sources are
changed during control panel operation. These changes can occur
directly by selecting another key source or also indirectly by changing
the Fill source or the Split mode. For storing the key settings in the key
memory two modes are available:
•
Auto Save
: If the switch Key Memory AutoSave=On, the settings of
the previous key signal are stored automatically before the settings
of the next key are recalled. If the switch Key Memory
AutoSave=Off, the stored settings of the new key are recalled
without saving the previous settings.
• Manual Storing : Key Memory AutoSave=Off. For storing the current
settings into the key memory, press the button of the respective Fill
source approximately 2 seconds. The storing is confirmed by a short
beep in the control panel.
•
Half M/E Mode
: Selects the Half-M/E mode: Normal M/E or DSK mode
• In Not coupled mode, this button can be used in any panel M/E to
delegate the panel M/E to the Half M/E. Once delegated, the Half
M/E can be used exactly like any other full M/E.