Graco E-Flo 333587D, Operation, Page: 24 / 110

Setup
24 333587D
When you select installed, the Serial Number will be
automatically populated to match the serial number
printed on the driver ID tag on Pump 2.
If Pump 2 has a heat module installed, press the
key in the Heat box to enable it.
Press the soft key to exit editing mode.
Style Definitions
Press the soft key at the iQ Menu screen 1 to
access the Style Definitions setup screens. This
function allows you to identify the style for dispensing
material and configure the settings of the style.
NOTE: Before accessing these settings, you need to
select if your system is running in Local or Remote
control mode. See Control Modes on page 41 .
NOTE: Through fieldbus only, a style number greater
than 16 can be passed over to the E-Flo iQ. However,
style definitions and delays must come from the
fieldbus.
Style Screen 1 - Style Definition
NOTE: When in Local control mode, you cannot select
Source at this screen, but you can still enter Values.
The Source fields can be changed in Remote control
mode.
1. Press the soft key to enter editing mode.
2. Enter a Style identifier from 0-16. This is the
designation the system uses for the type of
dispensing based on how you define the style here.
3. Bead is automatically selected as the Style Mode.
4. From the Source drop-down menus, select the
Pre-Charge and Flow Rate as either Local or
Fieldbus. When you select Local, enter the
appropriate corresponding number in the Value
column. A Fieldbus selection does not require a
value.