PART THREE - OPERATION
SECTION 4 - ANALYZER CONFIGURATION
Rev. 5-1000
Model C53 Conductivity Analyzer (universal-mount 1/2 DIN)
41
CONFIG TDS
Measurement (not needed
for other measurements)
Only when TDS is selected must the analyzer be further
configured to define a conductivity-to-TDS conversion
factor.
If CONDUCTIVITY or RESISTIVITY was selected,
disregard this subsection -- no measurement configuration
is needed.
1.
With the
',63/$< )250$7
&203(16$7,21
&21),* &21'8&7
&21),* /,1($5
&(// &2167$17
6(7 ),/7(5
38/6( 68335(66
(17(5 127(
7(03 (/(0(17
(;,7
screen displayed, use
Ø
Ø
key
to
select the “CONFIG TDS” line.
2.
Press
ENTER key
to display
6(7 )$&725
(;,7
.
3.
With the “SELECT FACTOR” line selected, press
ENTER key
to display
. Use
Ø
Ø
and
×
×
keys
to view both choices:
•
NaCl:
Analyzer uses the built-in NaCl conductivity-
to-TDS conversion factor.
•
USER DEFINED:
Analyzer uses a user-entered
conductivity-to-TDS conversion factor.
4.
With the desired choice displayed, press
ENTER key
to
enter this selection. If the “NaCl” conversion factor was
selected, TDS measurement configuration is complete.
If you selected “USER DEFINED,” you must enter a
conductivity-to-TDS conversion factor:
A.
With the
6(7 )$&725
(;,7
screen displayed, use the
Ø
Ø
key
to select the “SET FACTOR” line.
B.
Press
ENTER key
to display a screen like
. Use
arrow keys
to adjust the dis-
played value to the desired conductivity-to-TDS
conversion factor, and press
ENTER key
to enter
the value.
C. After the
6(7 )$&725
(;,7
screen re-appears, press
ESC
key
once to return to the “SENSOR A” submenu screen.
