Gladius G1220, User Manual

Page: 11 / 113

- ix -
Preface
Introducing the Rechargeable Battery Pack
With very little care, you can optimize the battery life and maximize the lifespan of the
battery. Most importantly, use only the computer in its ideal operating temperature (as
described in 1.3. Specifications on page 3 ) – do not leave it in a hot trunk during the
summer.
•
Important Terms to Understand
“Battery life” means the time the computer will run before it must be recharged
(sometimes this is also called “playtime” or “runtime”).
“Battery lifespan” means the total amount of time your battery will last before it must
be replaced.
• Using the Computer for the First Time
Be sure to fully charge (approx. 4 hours) the computer when charging the computer
for the first time.
• Long-Term Storage & Maintenance
If you are putting away the battery for more than three months, it is recommended that
the battery should be stored separately and fully charged, and get recharged every
three months. If you store an uncharged battery, it could fall into a deep worn-out
state which would render it incapable of holding any charge. Be sure to store your the
computer and battery at the proper temperature (as described in 1.3. Specifications
on page 3 ).
• Battery Lifespan
The removable batteries for the computer are designed to retain up to 80% of their
original capacity after 300 charging and recharging cycles when properly maintained.
You may choose to purchase new battery when it no longer holds the sufficient
charge that meets your needs.
General Cleaning Tips
You may need the following precautions before you begin to clean the device. When you
clean any single part or component for the device, please thoroughly read and understand
the details below.
1. We strongly recommended that you should shut down the system before you start to
clean any single components.
2. When you need to clean the device, please rub it with a piece of dry cloth.
3. Be cautious of the tiny removable components when you use a vacuum cleaner to
absorb the dirt on the floor.
4. Never drop the components inside the device or get circuit board damp or wet.