-8-
3.2 Installation
3.2.1 Opening the Package and Check
1. Open the package, take out the monitor accessories from the box carefully and place it in
a safe stable and easy to watch position.
2. Open the accompanying document to sort the accessories according to the packing list.
Inspect the monitor for any mechanical damages
Check all the accessories for any scratch or deformity, especially on connector, wire
and probe parts
If in doubt, please contact the local dealer or our company in case of any problems. We are
to offer you the best solution for your satisfaction.
3.2.2 Connecting the Power Supply
1. When powered by AC mains power supply:
Make sure that the AC mains power supply is within 100-250VAC with 50Hz or 60Hz.
Use the power cord provided by the manufacturer. Insert one end of it to the power
port of the monitor and the other end to the single-phase mains power outlet with
protected earth.
Caution: if necessary, make the monitor grounded properly by the provided
grounding wire.
2. When powered by built-in battery
Install battery: refer to Chapter 3.3.5 Battery Installation.
Caution: it’s better to recharge the battery after it is used up, the charging time
should be 13~15 hours long.
3.2.3 Starting the Monitor
The system performs self-test and enters initial display after switching on the monitor, and the
orange alarm indicator blinks to inform that the user can begin operating it.
Check all the applicable functions to make sure that the monitor works normally.
If the battery is applied please recharge it after using the monitor to ensure sufficient
power storage.
Do not use the device to monitor the patient if there are indications of damage or reminders of
error. Please contact the local dealer or our company.
It’s recommended to delay 1 minute to start it again.