9
Sterrad
F/O Larynogoscope Blades and Handles are compatible with:
Sterrad 100nx System (Standard and Express Cycle)
Sterrad nx System (Standard Cycle)
Sterrad 1005 and 200 System (Short Cycle Outside US)
Sterrad 50 System
Blade & Handle Test Procedure
Laryngoscope blades and handle should always be tested after cleaning/ disinfection/
sterilization and prior to use. To test connect the laryngoscope blade to handle and pull it to
the ON position as in Fig 2 if the unit fails to light or flicker, check the lamp/ batteries and the
electrical contacts, Be sure adequate supplies of spare lamps, batteries and replacement
parts are readily available if problem still persists, contact supplier please.
Warning
The above listed sterilization Guidelines, provided by GIMA are intended as
procedures compatible with specific materials. Sterilization must be performed to
approved Hospital protocol. GIMA can not guarantee sterility. This will be validated
by the hospital and or sterilization equipment manufacturers.
disposal:
The product must not be disposed of along with other domestic waste.
The users must dispose of this equipment by bringing it to a specific recycling
point for electric and electronic equipment.
For further information on recycling points contact the local authorities, the local
recycling center or the shop where the product was purchased. If the equipment
is not disposed of correctly, fines or penalties may be applied in accordance with
the national legislation and regulations.
GIMA WARRANTY CONDITIONS
Congratulations for purchasing a GIMA product.
This product meets high qualitative standards both as regards the material and the production.
The warranty is valid for 12 months from the date of supply of GIMA.
During the period of validity of the warranty, GIMA will repair and/or replace free of charge all
the defected parts due to production reasons. Labor costs and personnel traveling expenses
and packaging not included.
All components subject to wear are not included in the warranty.
The repair or replacement performed during the warranty period shall not extend the warranty.
The warranty is void in the following cases: repairs performed by unauthorized personnel or
with non-original spare parts, defects caused by negligence or incorrect use.
GIMA cannot be held responsible for malfunctioning on electronic devices or software due
to outside agents such as: voltage changes, electro-magnetic fields, radio interferences, etc.
The warranty is void if the above regulations are not observed and if the serial code (if available)
has been removed, cancelled or changed.
The defected products must be returned only to the dealer the product was purchased from.
Products sent to GIMA will be rejected.
ENGLISH