Generation II RF Control System – Operating, Installation & Technical Manual
RF Gen II System Technical Manual Rev02_12_10
9
Speed Mode Screen
In Speed mode, the machine will maintain a consistent feed-rate relative to ground speed.
The feed rate percentage is adjustable from 1
– 100%.
Screen Features:
The top line shows the feed rate.
The bottom line of the screen shows the status of the system (STOP), the mode of operation
(Speed) and connectivity status.
Additional features that show if load cells are fitted:
The second line shows the weight fed out since the wagon was loaded.
The third line shows the present wagon weight. This may be gross or tare.
The bottom line of the screen shows the status of the system (STOP), the mode of operation
(Speed), the battery voltage (highest voltage available to the unit. When disconnected from the
tractor, this will be the internal battery voltage), and connectivity status.
Operating Notes:
Screen Warnings:
“WAGON POWER NOT CONNECTED” will display if the GO button on the Remote Display is
pressed without the wagon being plugged into the tractor and/or power not getting from the tractor
to the Controller.
FEED RATE:
50%
STOP Speed
FEED RATE:
50%
DISPENSED:
940kg
GROSS:
3540kg
STOP Speed 12.5V
Rate control only
Rate control and
load cells fitted
Feed Rate
System status
Mode of operation
Connectivity status
Dispensed amount
Product weight in machine
Battery voltage
System battery indicator
The operator can alter the feed-out rate by adjusting the rate percentage by
pressing UP or DOWN on the keypad while in STOP mode only.
The operator can adjust the weight to be dispensed by adjusting the ‘TO
FEED’ figure. This is done by pressing UP or DOWN on the keypad when
the ‘TO FEED’ figure is underlined. Use the RIGHT or LEFT button to move
the underline cursor.
The operator can start or stop the feed-out by pressing GO or STOP on the
keypad.
The operator can zero only the dispensed weight by pressing GO on the
keypad.
The operator can switch to other available operating modes by pressing
MODE on the keypad.
The operator can select between gross and tare weight to be displayed by
pressing TARE/GROSS on the keypad.
The operator can zero the gross and dispensed weight by pressing ZERO
on the keypad.
