Generation II RF Control System – Operating, Installation & Technical Manual
RF Gen II System Technical Manual Rev02_12_10
5
Remote Display Screens
Screen Symbols
Apart from usual text characters, the screen can display other symbols at various times.
Start-up Screen
When the Remote Display is powered up, the start-up screen is displayed for 3 seconds as
below. After this the screen will change to the operating screen.
If the wagon is not connected i.e. not getting power from the tractor, the controller will not
start. The screen below will display until communication has begun by plugging in the wagon
or pressing and holding the GO button on the controller for 1 or more seconds.
After establishing communication, it will proceed directly to the next screen.
Once communication has begun between the devices, a screen similar to the one below will
show.
The modes that are available are dependant on the hardware options fitted to the machine.
The battery symbol indicates when the system is operating on its own battery. The
voltage display indicates the condition of the battery.
The antenna symbol indicates when the Controller and Remote Display have
communication between them. This must show at all times for successful operation.
GILTRAP GEN II
CONTROL SYSTEM
Channel: 1 Rev
3.4
Remote Display software
revision
Remote Display RF
channel
FEED RATE:
50%
DISPENSED:
0kg
GROSS:
2950kg
STOP Std 12.5V
Waiting for
RF Forage Wagon
Communications...
