Generation II RF Control System – Operating, Installation & Technical Manual
RF Gen II System Technical Manual Rev02_12_10
10
Scales Screen
In Scales mode, the screen will only display weight figures. This mode is used when no rate
control is fitted to the wagon.
No other modes are available if only load cells are fitted.
The operator can enter a target weight to feed when a beeper will sound, the wagon floor will
stop moving (if the floor control solenoid is fitted) and the system status will return to STOP.
Features:
The top line shows the weight to feed out before a beeper sounds.
The second line shows the weight dispensed since GO was pressed.
The third line shows the tare or gross weight in the machine.
The bottom line of the screen shows the mode of operation (Scales), the battery voltage (highest
voltage available to the unit. When disconnected from the tractor, this will be the internal battery
voltage), and connectivity status.
Operating Notes:
Screen Warnings:
None
TO FEED:
560kg
DISPENSED:
733kg
GROSS:
3440kg
STOP Scales 12.5V
Mode of operation
System status
Target weight to feed
Dispensed amount
Amount in machine
Connectivity status
Battery voltage
System battery indicator
The operator can adjust the weight to be dispensed by adjusting the
‘TO FEED’ figure. This is done by pressing UP or DOWN on the
keypad when the ‘TO FEED’ figure is underlined. Use the RIGHT or
LEFT button to move the underline cursor.
The operator can select between gross and tare weight to be
displayed by pressing TARE/GROSS on the keypad.
The operator can zero only the dispensed weight by pressing
GO on the keypad.
To allow the dispensed weight to accumulate and the target
feed weight to work, the operator must press GO before
commencing feeding.
The operator can zero the gross weight and dispensed weight
by pressing ZERO on the keypad.
