Gill Metpak, User Manual

Page: 100 / 103

Gill Instruments Ltd
_____________________________________________________________________________________________________________
________________________________________________________________________________________________
MetPak/MetPak RG and MetPak Pro Base Stations
Page | 100 Issue 1
Doc. No. 1723-PS-0023 October 2018
8.3.2. MetPak Base Station Range Sensor Status Codes
Code Status Condition
00 OK
No fault conditions detected in
measurement period.
A Acceptable Data (NMEA Mode)
No fault conditions detected in
measurement period.
01 Wind Sensor Axis 1 failed U Axis blocked or faulty.
02 Wind Sensor Axis 2 failed V Axis blocked or faulty.
04 Wind Sensor Axis 1 and 2 failed U and V axis blocked or faulty.
08 Wind Sensor NVM error
Non Volatile Memory checksum failed,
data could be uncalibrated.
09 Wind Sensor ROM error
Read Only Memory checksum failed, data
could be uncalibrated.
0B Wind Sensor reading failed. Wind Sensor faulty.
10 Hygroclip error Hygroclip faulty.
20 Dewpoint error Hub Pec faulty.
40 Humidity error Hygroclip faulty.
66 Wind Sensor Power Check Wind Sensor is powered
67
Wind Sensor RS232
Communications
Check Wind Sensor RS232 wiring
80 Pressure Sensor Warning
Pressure sensor reading not available/unit
faulty.
XX More than one fault
Fault condition that can be the sum of
0B,10, 20 or 40. e.g. 1B would mean that
both the Wind Sensor (0B) and Hygroclip
(10) were faulty.
V
Void Data, Wind Sensor reading
failed (NMEA mode)
Wind Sensor faulty.