GILES GBF Series, Operation & Service Manual

Page: 45 / 130

Pre-Operation
GBF Ventless Electric Fryer
GBF-35D & 50D-VH
33
9. Moisture on the elements should quickly dry and heat should be felt rising from the vat. DO NOT TOUCH THE
ELEMENTS DURING THIS TEST! Proceed to Section 4.04 below.
If Heating Elements do not dry within 15 - 30 seconds or no heating is detected, refer to Section 7.01,
Troubleshooting Procedures .
1. Follow steps shown in Section 4.01 .
2. Liberally dampen a sponge, or towel, with water and wipe down Heating Elements ① leaving them visibly
moist.
4. Set the Power Switch ② to the [ON] position.
5. The temperature set-point value displayed on the Digital Thermostat ⑨ should be greater than 300
°F.
If it is
not, change the setting to a value of 300
°F
or higher (see Section 5.01.2, Setting the Cooking Temperature for
instructions).
6. Set the Selector Switch ⑤ to the [COOK] position. The HEAT light ⑥ should turn ON . Leave switch in the
[COOK] position for NO MORE THAN 10 to 12 SECONDS .
7. Return Selector Switch ⑤ to the [OFF] position.
8. Moisture on the elements should quickly dry and heat should be felt rising from the vat. DO NOT TOUCH THE
ELEMENTS DURING THIS CHECK! Proceed to Section 4.04 .
If Heating Elements do not dry within 15 - 30 seconds or no heating is detected, refer to Section 7.01,
Troubleshooting Procedures .
2
6
5
9
4.03.1 Heating Element Test, Computer Controller - continued
4.03.2 Heating Element Test, Manual Controls
The Heating Elements quickly become extremely hot when energized! Skin contact may result
in severe burn injury.