67
Configuring the Advanced Settings
Gigaset SE366 WLAN / englisch / A31008-M1063-R101-4x-7619 / configure_router.fm / 13.11.2008
Sc
hablone 200
4_12
_27
SSID broadcast
If this option is enabled (default setting), the Gigaset SE366 WLAN will send the SSID
with all data transmissions and your Gigaset SE366 WLAN's SSID will be displayed on PCs
that have a wireless network adapter. In this case, eavesdroppers could use the SSID to
gain access to your local network.
If you disable
SSID broadcast
, your Gigaset SE366 WLAN's SSID will not be displayed.
This increases protection against unauthorised access to your wireless network. How-
ever, you must make a note of the SSID. You will need it to log in to your PC.
ì
Select the
Off
option to deactivate
SSID broadcast
.
Sending power
ì
Select the required sending power for your device.
We recommend that you select a sending power with a range to suit the spatial environ-
ment of your local network. A range that is much greater makes it easier to eavesdrop
on your wireless data transmission.
Channel bonding
You can only use
Channel bonding
if this function is supported by at least one client in
your wireless network. For the best possible data transfer rates, all clients in your wire-
less LAN should support
Channel bonding
.
ì
Select an option for
Channel bonding
from the list:
20 MHz
,
40 MHz
or
40/20 MHz
Auto
(default).
Network performance
You can optimise network performance in the following ways:
u
Optimize throughput
maximises the data transmission rate in your network and ensures that data traffic
is transmitted immediately.
u
Optimize power saving
optimises power consumption in order to extend standby times for mobile devices
in your network, e.g. notebooks, PDAs and WLAN handsets.
u
Custom
This allows you to adjust the netwoek performance to suit your needs on the basis
of the following items:
–
Beacon interval
defines the interval between two
.
Measured in milliseconds, default = 100 msecs.
–
DTIM interval
defines the interval between two
for devices in power-
saving mode.
Measured in number of beacons, default = 2 beacons.
ì
Choose the desired
Network performance
.
