55
P83173A RevA
7/19/10
Chapter 5:
Printing Jobs on the Gerber CAT | UV
This chapter describes how to print jobs on the Gerber CAT|UV including choosing the print
mode, viewing job information, starting and stopping jobs.
Using RIP software and profiles
The quality of the RIP (raster image processing) software can be very important when printing
photo-realistic images. Gerber-authorized software has been approved to work with the Gerber
CAT|UV and Gerber inks and materials. Following is a list of approved software at the time of
printer introduction. Consult the GSP web site www.gspinc.com for an up-to-date listing.
♦
Onyx® ProductionHouse™, Onyx PosterShop™, or Gerber CAT|UV Onyx Driver
version X10 or higher (to ensure compatibility with the printer)
♦
ErgoSoft
♦
Caldera™
Gerber-authorized RIP software employs carefully engineered color profiles to produce crisp
images and smooth tonal transitions. Be sure to choose the correct device profile for the material
and print quality that you have chosen. Using the wrong device profile can result in shifting
colors and unsatisfactory results. If you are using a material that does not have a profile
available, use a profile for a similar material. It is recommended that you print a small “test” job
to verify the expected results before printing large jobs.
Print mode options
The Gerber CAT|UV can set to print in several print modes. Refer to the chart on the following
page for estimated print speeds and printing direction. Values shown are derived from printing
on vinyl material.
When choosing the print quality, you make a choice of speed vs. quality. The highest quality
printing uses the slowest speed. Choosing the correct print quality for the job is dependent on
the type of results that you require and the intended viewing distance.
