Administrator Mode
147
4
4
Password:
Type a valid password to enable the UMTS service from
your network operator.
Maximum Transmission Unit:
Type the Maximum Transfer Unit
(MTU). The default value is
1500
.
Retain UMTS Connection:
Select this option to check the UMTS
connection status and use the drop-down list to specify the desired
time length for check frequency. The GV-Video Server will rebuild the
connection if disconnection is detected.
Enable VPN Connection:
Select this option to enable the VPN
(Virtual Private Network) connection. Type the target IP address in the
Check Target IP Address
field.
UMTS Authentication Protocol:
Use the drop-down list to select the
UMTS Authentication Protocol provided by your network operator.
Enable Schedule Mode:
Starts the UMTS connection automatically
based on the schedule you set in the
Select Schedule Time
section.
Refer to
4.6 Recording Schedule
for the same settings.
Enable DNS:
Optional type up to two DNS servers of your network
operator.
3G Connection Status:
Indicates the connection status of UMTS or
VPN.
Note:
1.
When both WiFi and 3G signals are detected, the camera will
connect to the network through WiFi.
2. UMTS Settings are not supported by GV-EBL2101 / 2111 / 3101 /
5101.
Summary of Contents for GV-PTZ010D
