GeoVision GV-PTZ010D, Firmware Manual, Page: 140 / 257

Administrator Mode
119
4 4
To enable connection to GV-Backup Center:
1. Activate Link : Enable the connection to the GV-Backup Center.
2. Host Name or IP Address : Type the host name or IP address of the
GV-Backup Center.
3. Port Number : Match the communication port on the GV-Backup
Center or keep the default value 30000 .
4. User Name : Type a valid user name to log into the GV-Backup
Center.
5. Password : Type a valid password to log into the GV-Backup Center.
6. Backup Video : Select the streams to back up their recordings to the
GV-Backup Center.
7. Compact Video : Select the streams to only back up their Key Frames
to the GV-Backup Center, instead of full recordings. This option is
useful to save the backup time.
8. Resend all files : Select this option to send all the recorded files that
have received by the Backup Center again.
9. Enable Schedule Mode : Enable the GV-Backup Center connection
on the schedule you set in the Select Schedule Time section. Refer to
4.6 Recording Schedule for the same settings.
10. Click Apply . The Connection Status should display “Connected” and
connected time.
If you have a failover GV-Backup Center server which provides
uninterrupted backup services in case the first GV-Backup Center failed,
configure the failover GV-Backup Center as below.
1. Automatic Failover Support : Enable the automatic connection to the
failover GV-Backup Center once the connection between camera and
the first GV-Backup Center is interrupted.