Document #: GP-UM-PDLE-101-11
Page 50 of 61
→
Internet Protocol
→
Properties:
Notes:
•
To connect the instrument directly to a PC, use a PC to PC cable. To connect the
instrument to a LAN, use a standard network cable.
•
For Ethernet control, the serial port is only used during Ethernet setup (if using
the LabView Ethernet setup program).
•
The remote control command formats for Ethernet and RS-232 are exactly the
same.
4.4.4. Remote Control Program Interface
LabView based control programs are provided for computer control of the PDLE-101
through different control interfaces. If the LabView development environment (version
8.2 or above) is installed on the control computer, either the source code (vi) or the
executable versions of the remote control programs can be used without installing further
drivers. To control the PDLE through the USB port, the USB drivers need to be installed
(see section 4.4.2)
Note: For simple control of the instrument, it is often easier to use the executable versions
of the program than the source code. However, the executable versions will not run
properly while LabView is running. If using the executable versions of the program on a
computer with LabView installed, the user should quit LabView before running them.
Select this
option
Summary of Contents for PDLE-101
