b)
LabView program:
A LabView program provided with the instrument can also be used to query the
IP address and perform static IP setup.
Open the LabVIEW program
(GP_SET_ETHERNET.vi or
GP_SET_ETHERNET.exe)
to set the Ethernet configuration.
NOTE: This program was designed for an RS-232 interface, so the instrument
should be connected to the computer via RS-232 before running it. Please see the
instructions at the beginning of section 4.4.1 for preparations to run an RS-232
LabView program. The program interface is shown below.
Select the correct serial (RS-232) port from the port configuration box at the top
of the screen. The baud rate should be set to 9600. Once these two parameters are
set, click the white arrow to run the program.
The program has 3 tabs. The first, “GET IP CONFIG” is used to query the current
IP configuration of the PDLE-101. When the “Get IP Config” button at the left of
the screen is clicked, the program will read back the instrument’s current IP
address, net mask, gateway, nameserver, and port, as well as whether the
instrument is currently set for static or dynamic IP addressing.
IP Config query screen- Static IP mode result
Document #: GP-UM-PDLE-101-11
Page 43 of 61
Summary of Contents for PDLE-101
