Click the “Random Enable/Disable” button to enter random mode. The interface screen is
displayed above.
The indicator boxes in the middle of the screen display the waveform/trigger status,
frequency, and scan limits.
If the trigger is off, the waveform/trigger status indicator box (top left) will display the
waveform type (RAN. WAVE), and the frequency box will display the selected
frequency. If the trigger is on, the waveform/trigger status box will display the waveform
type, trigger status, and selected trigger edge, ex. (RAN. TRG Rise), and the frequency
box will display “FRQ: Trigger”, indicating that the frequency corresponds to the
frequency of the trigger signal.
To set the frequency and PDL limit values, type the desired values in the corresponding
boxes at the bottom of the screen and either press ENTER or click outside the box whose
value has just been modified.
Ranges:
Frequency: 0.1 to 100 Hz
Max. PDL: 0.2 to 20 dB
Min. PDL:
0.1 to 19.9 dB
Document #: GP-UM-PDLE-101-11
Page 58 of 61
Summary of Contents for PDLE-101
