GE Portrait Hub01, User Manual

Page: 124 / 198

Cleaning, disinfection, and care
Cleaning procedure for the charger
Initiate cleaning and disinfection as soon as possible after use (recommended within 1
hour). Remove any soil as soon as possible by wiping the device to prevent the drying
of soil on the device as described in following procedures.
Soiled devices must be separated from non-contaminated devices to avoid
contamination of personnel or surroundings.
Preparing the charger for cleaning
1. Remove sensor batteries, sensors, and Hub from the charger.
2. Unplug the power cord from the wall outlet.
3. Visually ensure that the device is intact. Evidence of damage may include, but is
not limited to, discoloration, excessive scratches, wear, and cracks.
Cleaning the charger
In case there is some dried or gross soil, perform pre-cleaning by wiping with a soft,
clean non-linting cloth saturated with lukewarm tap water (temperature range 27 to
44°C, 81 to 111°F) until visible dried or gross soil is removed.
1. Dampen a soft non-linting cloth with detergent or use ready-to-use detergent
wipes.
Prepare the detergent according to the manufacturer’s instructions.
2. Wring excess liquid from the cloth (wet but not dripping).
3. Wipe the exterior surface. Ensure that the entire surface is wet and make sure all
surfaces are uniformly cleaned.
●
Pay special attention to hard-to-clean areas (marked here with red), like
grooves and crevices:
Use cotton swabs to access hard to reach areas. Do not use any sharp tools to
clean the device.
4. Replace soiled and/or dry wipes or non-linting cloths as needed.
5. Repeat the cleaning until the device is visibly clean.
6. Discard disposable wipes or non-linting cloths according to your hospital
guidelines. Do not reuse wipes.
124
Portrait ™ Mobile Monitoring Solution
5815148-01