GE Portrait Hub01, User Manual

Page: 117 / 198

Cleaning, disinfection, and care
7. Rinse the device thoroughly using a soft, clean non-linting cloth saturated with
lukewarm tap water (temperature range 27 to 44°C, 81 to 111°F).
8. Allow the device to air dry until it is visually dry, or dry thoroughly with a soft,
clean, non-linting cloth before placing the device into the charger.
●
Pay special attention to metal parts (marked here with a red ellipse) when
drying device to avoid corrosion:
Drying times may vary based on the environmental conditions. Do not let fluid
pool around connection pins to avoid corrosion. If this happens, blot dry with a
cotton swab or soft cloth.
Post-cleaning inspection
Inspect devices visually after cleaning and prior to disinfection for the following:
●
Cleanliness
￭
If there is any visible soil present, repeat the cleaning procedure until no visible
soil remains.
●
Damage, including, but not limited to, corrosion (rust, pitting), discoloration,
excessive scratches, flaking, cracks, and wear
●
Missing or worn device labeling or marking
Do not use devices that are not functioning properly or are damaged, or have
unrecognizable markings, or missing or worn device labeling or marking.
Cleaning procedure for the respiration sensor
Initiate cleaning and disinfection as soon as possible after use (recommended within 1
hour). Remove any soil as soon as possible by wiping the device to prevent the drying
of soil on the device as described in following procedures.
Soiled devices must be separated from non-contaminated devices to avoid
contamination of personnel or surroundings.
5815148-01
Portrait ™ Mobile Monitoring Solution
117