GE Portrait Hub01, User Manual

Page: 121 / 198

Cleaning, disinfection, and care
3. Wipe the cable and all sensor surfaces, including the lenses. Ensure that the entire
surface is wet and make sure all surfaces are uniformly cleaned.
●
Pay special attention to hard-to-clean areas (marked here with red), like
grooves and crevices:
Use cotton swabs to access hard to reach areas. Do not use any sharp tools to
clean the device.
●
Finger probes can be turned inside out to enable easy cleaning of the inner
surface.
●
Do not damage sensor connector pins when cleaning or drying.
4. Replace soiled and/or dry wipes or non-linting cloths as needed.
5. Repeat the cleaning until the device is visibly clean.
6. Discard disposable wipes or non-linting cloths according to your hospital
guidelines. Do not reuse wipes.
7. Rinse the device thoroughly using a soft, clean non-linting cloth saturated with
lukewarm tap water (temperature range 27 to 44°C, 81 to 111°F).
8. Allow the device to air dry until it is visually dry, or dry with thoroughly with a soft,
clean, non-linting cloth before placing the device into the charger.
Drying times may vary based on the environmental conditions. Do not let fluid
pool around connection pins to avoid corrosion. If this happens, blot dry with a
cotton swab or soft cloth.
●
Pay special attention to metal parts (marked here with red) when drying device
to avoid corrosion:
5815148-01
Portrait ™ Mobile Monitoring Solution
121