GE Portrait Hub01, User Manual

Page: 104 / 198

Pulse oximetry and pulse rate
3. Connect the sensor battery to the sensor and attach the probe to the patient’s
finger:
When using a wrap sensor, make sure to position the
light source (1) directly opposite the detector (2). This
graphic shows the attachment of the probe to the
attachment accessory band.
4. Wrap the attachment band to the patient’s wrist. Peel off the adhesive liner,
place the back of the sensor to the revealed adhesive area and attach the Velcro
support straps around the sensor:
5. Adjust the cable length according to the size of the patient's hand by positioning
the sensor in one of the ways shown below.
or
Make sure that the attachment band is not too loose or too tight.
6. Secure the cable to the back of the hand to minimize probe movement. Do not
restrict circulation.
7. Pair the sensor and Hub.
8. Check the measurement.
Using the P-SA01 and P-SP01 sensors
These P-SA01 and P-SP01 sensor-specific instructions explain the use in more detail.
Also follow the generic instructions for starting the SpO
2
measurement.
104
Portrait ™ Mobile Monitoring Solution
5815148-01