GE Hydran 201i, Instruction Manual

Page: 34 / 300

Chapter 1 • Introduction
1-8 Rev. 6, March 2011 Part 17997
• Hydran 201 i System Incipient Fault Monitor: Combination of H201T i ’s and H201C i ’s.
Can be abbreviated as follows:
– Hydran 201
i System
• Hydran Host Software: Used for interface between the user and a network of H201T i ’s.
Can be abbreviated as follows:
– Hydran Host
1.5 ACCESSORIES
The following accessories are available for the Hydran 201 i System. They may be ordered
from General Electric Canada with any of the Hydran 201 i System components or
separately.
1.5.1 Hydran 201TW Tube Wrench
The Hydran 201TW Tube Wrench (Figure 1-4 on page 1-8) is required to properly install
the Hydran 201 sensor. One Tube Wrench per site is recommended.
1.5.2 Vibration-Absorbing Rubber Pads
If vibrations are present, these rubber pads (which can be purchased from General Electric
Canada) are used on the back of the Hydran 201C
i Controllers; an example is shown in
Figure 1-5 on page 1-9. Refer to Chapter 3.
Figure 1-4 - Hydran 201TW Tube Wrench