GE H45011DT, Service Manual

Page: 452 / 594

GE M
EDICAL
S
YSTEMS
D
IRECTION
2392751-100, R
EVISION
3 V
IVID
™ 4 S
ERVICE
M
ANUAL
Chapter 8 - Replacement Procedures 8-69
8-5-12-4 MO Drive Installation Procedure
Note: Before installing the new MO Drive, make sure the MO Drive jumper settings are shorted
as shown below:
1) For BEP2 :
Use the metal tracks provided with the MO drive, or use those from the drive previously removed.
See note below.
2) Carefully slide the MO Drive into the front of the BEP (refer to Figure 8-52 on page 8-68).
For BEP2 systems, secure the MO Drive in position with the four screws (two on each side).
3) From the BEP rear, remove the empty panel (2nd from the top) and insert the SCSI card see SCSI
Board Installation Procedure on page 8 - 61.
4) Connect the data cable between the SCSI card and the rear of the MO Drive.
5.) Connect the power cable to the rear of the MO Drive. Make sure that Pin 1 is aligned with the red
line on the flat cable.
6.) If applicable, install the octopus card holder as described in the BEP2 - Octopus Card Holder
Installation Procedure on page 8 - 56.
7) Install the BEP left and right side covers, as described in the BEP2 - Side Cover Installation
Procedure on page 8 - 54.
Note: If this MO Drive installation is newly-installed hardware for this system, the kit should have
been provided with a set of sliders for BEP2, and also a front cover for BEP2.
Refer also to the SCSI card installation instructions in the
SCSI Board Installation Procedure
on page 8 - 61.
A2 to B2
A9 to B9
A11 to B11
Settings required: