GE Corometrics 250cx Series, Service Manual, Page: 66 / 252

3-12 250cx Series Maternal/Fetal Monitor Revision C
2036947-001
Installation: Service Mode Screens
Mounting a Strain Gauge
To mount a strain gauge post, refer to the manufacturer’s directions.
Setup Screens
The 250cx Series Monitor provides a variety of options that are all selected using
setup screens shown on the display. All functions are performed easily using the
front panel Trim Knob. The following setup screens are selectable from the display:
„
FECG
„
US
„
US2
„
Maternal NIBP
„
MSpO
2
„
MHR/P
„
Master Alarm
„
General Setup
For information on individual setup screens, refer to Chapter 5 of the Corometrics
250cx Series Monitor Operator’s Manual. For information on default settings, refer
to the Table ,
“Factory Defaults,”
on page 3-23.
Service Mode Screens
The 250cx Series Monitor is programmed with five service mode screens. These
screens are listed below:
„
Service Lock
„
Install Options Screen 1
and
2
„
Error Log
(Refer to
“Self-Test Routine”
on page 4-17.)
„
Communications Setup
(Also, refer to
“Peripheral Components”
on page 2-14.)
„
Diagnostic Control
(Refer to
“Self-Test Routine”
on page 4-17.)
„
NIBP Calibration
5 9
1