Page 4 - 15
Installation
Orca III/ Orca III T Operation and Maintenance Manual
© GBC Films Group February 2001
4.12 Slitter assemblies
C A U T IO N
E xercise extrem e caution w hen w orking
w ith the slitter assem blies.
SH A R P K N IF E C A N C U T Y O U !
The slitter assemblies provide a method of
trimming the left and right sides of the print and trimming
of the left and right sides of the finished product when
used in a roll to roll application.
Tools required
• ( 1 ) Modified 1/4 in. allen wrench
( from the accessory pack )
• (1) 1/4 in. allen wrench
( from the allen wrench set in the accessory pack)
• The center piece from the brake pad.
( step d) in Section 4.11 Unwind/rewind brake)
a) Cut the center piece of the brake pad as illustarted
below.
1
2
3
4
b) Place the pieces ( 1,2,3 & 4 ) on the slitter idler
stand offs as illustrated below.
S ta n d o ffs
P ie c e s o f c u t p a d
c) Use the 1/4 allen wrnech to secure two slitter
assemblies to the front tie bar below the slitter
idler.
T ie b a r
S litte r
a s s e m b ly
S litte r id le r
d) Rest one on each side of the slitter idler so the
blade is resting on the pad of the standoffs.
P a d
C A U T IO N
N ever leave th e slitter assem blies unsecured .
A lw ays secure in the proper rest p osition.
U nsecured blade can cu t you!