Page 7 - 4
Troubleshooting
Orca III/ Orca III T Operation and Maintenance Manual
© GBC Films Group February 2001
7.3 Machine problems
Once the Hints are all checked, and your problem
still exists, a service call must be placed for a qualified
service personnel to fix the problem.
You may do this by dialing 1 ( 800 ) 790 - 7787.
This will connect you with GBC National Service dispatch
. You will be required to give the serial number of your
machine when placing a service call.
A space below has been provided to keep this
number readily available if and when needed.
My Orca III/ Orca III T Laminator serial # is:
At no time does GBC Films Group suggest or
recommend that you attempt to fix the machine by opening
the cabinets or covers yourself.
W A R N I N G
Do not wear ties, loose fitting clothing or
dangling jewelry while operating or
servicing the laminator. These items can get
caught in the nip and choke you or you can
be crushed or burned.
Problem : No control panel functions
Hints : • Ensure an E-STOP has not been pushed
down
• Reset the main roller UP/ DOWN switch.
• Confirm that the MAIN POWER is to the
ON position.
• Be sure power is supplied to the laminator
Problem : I can only operate using the footswitch.
Hints : • Ensure nothing is blocking the PHOTO-EYE.
Problem : I press AUTO and the motor will not turn.
Hints : • Ensure nothing is blocking the PHOTO-EYE.
• Ensure an E-STOP has not been pushed
down
• Ensure the FWD/ REV switch is not in the
middle position.
• Reset the main roller UP/ DOWN switch.
Problem : Jerking, stuttering, or excessive noise from
the laminator.
Hints : • Check for excessive brake tension
• Confirm that the rolls of laminate are on
correctly.
• Place a service call.
