![background image](http://html.mh-extra.com/html/gbc/orca-iii-t/orca-iii-t_operation-and-maintenance-manual_571024044.webp)
Page 4 - 9
Installation
Orca III/ Orca III T Operation and Maintenance Manual
© GBC Films Group February 2001
4.6 Accessory pack
Once the Orca III/ Orca III T Laminator has been
unpacked and moved into final position, open the accessory
pack and verify the contents.
Accessory Pack contents
• (1) 1/4 T-handle allen wrench - 475-210
• (1) Set SAE allen wrenches - 475-230
• (1) Modified 1/4 allen wrench - 485-001
• (1) Zippy knife - 475-620
• (1) Rubber cement pad - 930320
• (1) Roll masking tape - 475-000
• (1) Tape measure - 475-100
• (1) Operators manual - 930-062
• (1) Main power strain relief - 175-201
• (1) Unwind/ rewind brake - 625-006
• (1) Unwind/ rewind brake pad - 375-000
• (1) Air hose with fittings - 360-000
• (1) Coupling, 1/4, air fitting - 333-000
• (4) Polyurethane O-rings - 480-005
• (4) Fuses, SB, 3.0AG - 186-200
• (4) Leveling pads - 470-100
C A U T IO N
E xercise extrem e caution w hen rem oving
the slitter assem blies or the rotary blades.
Sharp knife can cut you !
• (1) Circular blade - 475-001
• (4) Slitter assemblies - 001-122
If you are missing any of the items listed above,
contact your local service technician or sales
representative.
4.7 Electrical Connection
The Orca III/ Orca III T laminator requires 220
~ 240 VAC electrical power for proper operation. The
power supply may be either single phase or three phase
(five wire or four wire). For single-phase power, a 55
amp service is required and for three-phase power, 25
amps per phase is required.
The Orca III/ Orca III T requires the electrical
power cord to be wired directly to the line terminal block
located within the control side cabinet.
Before the machine is installed, a qualified
electrician must route the proper wiring to the location
where the machine will be stationed. The machine then
can be connected to the power supply by a qualified
electrician following one of the three instructions listed
below.
ELECTRICAL
S H O C K
Only a qualified electrician should connect
power to the laminator. You can be severely
shocked, electrocuted or cause a fire if
power is improperly applied.
E L E C T R IC A L
S H O C K
D o n ot allow anything to rest on the
pow er cord. D o not locate the cord w here
peop le can w alk on it. Y ou or others can
be severely shocked, electrocuted or
cause a fire.