![background image](http://html1.mh-extra.com/html/gaui/x5-3d-flybarless/x5-3d-flybarless_operating-instructions-manual_3802338055.webp)
55
1 x brief
2 x brief
3 x brief
4 x brief
1 x long
1 x long
1 x long
1 x long
1 x brief
2 x brief
3 x brief
Braking
Off
soft
hard
very hard
Battery type
Lithium
NiMH
Cut-off mode
soft
hard
Cut-off switching threshold
low
medium
high
Start mode
normal
soft
very soft
Timing
0°
3,75°
7,5°
11,25°
15°
18,75°
22,5°
26,25°
Governor mode
Off
low
high
Unused menu item 1
Clock signal
12 kHz
8 kHz
BEC voltage
5.25 V
6 V
Unused menu item 2
LiPo cells
Auto
2S
3S
4S
5S
6S
3. Adjusting values
• In the setting mode, you will now also hear different signals (see top line of the following table), which repeat in a
continuous loop. The red LED flashes at the same rhythm. The point where the sequence starts again depends on the
menu item set, since only those sounds are emitted for which a value is set and stored as well.
• After the sound signal for the desired value, slide the throttle control lever from the bottom-most position (motor off)
to the full throttle position at once.
• 4 sounds are emitted as confirmation for the stored value.
• The speed controller returns to the programming mode, where you can call and set the next menu item if required.
The standard settings are displayed on a grey background in the table
4. Leaving the programming mode
• If the controller is in programming mode, wait until menu item 14 is acoustically displayed. Then slide the throttle
control lever from the full throttle position to the bottom-most position (motor off) within 3 seconds of the sound
signal. First, you will hear 5 separate sounds, then the motor emits the sequence for commissioning.
• Once the controller is in setting mode and you have stored a new value, pull the throttle control lever back to the
bottom position(motor off) right after the confirmation sound sequence. First, you will hear 5 separate sounds, then
the motor emits the sequence for commissioning.
Technical Data
Power supply .................................................. 2 – 6 LiPo-cells or 5 – 18 NiMH-cells
Continuous current ......................................... 100A
Peak current ................................................... 150 A
BEC output power .......................................... 5.25 / 6 V, 4 A
Dimensions .................................................... 75 x 35 x 17 mm
Weight ........................................................... 82 g