Gateway 930 series, System Manual

Page: 60 / 160

52
Replacing and Adding System Components
6
Insert the new DIMM into the socket and align the two notches in the
DIMM with the two notches in the DIMM socket.
7
Gently press the DIMM into the socket until it is firmly seated. Inserting
the DIMM automatically locks the socket latches on each end of the
DIMM.
8
Replace the bezel. (See “Replacing the bezel” on page 28.)
9
Close the case. (See “Closing the case” on page 27.)
10
Reconnect the power cord, modem cord, and all other external peripheral
devices, then turn on the system.
To add DIMMs:
1
Turn off the system and disconnect the power cord, modem cord (if
installed), and all external peripheral devices.
2
Observe all safety and static electricity precautions. (See “Preventing static
electricity discharge” on page 22.)
3
Remove the bezel. (See “Removing the bezel” on page 25.)
4
Remove the left side cover panel. (See “Removing the side cover panel”
on page 26.)
8508088.book Page 52 Thursday, November 1, 2001 9:35 AM