69
DISASSEMBLING THE BLENDER JUG AND REMOVING STUBBORN RESIDUES
WARNING:
The blade is very sharp! Do not touch the blade. To handle the blade,
always hold on to the blade assembly housing.
1. Take the blender jug off the motorblock and hold it over the sink. Remove the holder tur-
ning it ¼ of a turn clockwise. Take the holder off the blender jug and remove the blade.
ATTENTION:
The blender jug might be connected really tight to the holder. Do not use
force unscrewing it.
2. Rinse all parts in warm soapy water. Soak stubborn residues for a few minutes and
then remove them using a nylon washing brush or sponge. Do not cut yourself.
Beware not to damage the sealing ring. If you can not get the sealing ring clean or
if it is porous or damaged you have to replace it. Contact your vendor for replace-
ment parts.
3. After cleaning rinse all parts with clear water and dry them carefully. You can also
leave all parts dry naturally where they are out of reach of young children. When
the parts are dry assemble the blender jug for storage or usage.
CLEANING THE MOTORBLOCK
WARNING:
Do not place the appliance in an automatic dishwasher or pour boiling
water over it. Do not immerse the motor or power cord in any liquids or spill any liquids
on it or place the motor on wet surfaces. Always wipe off spilled liquids immediately.
Ensure that no water can run into the louvre. When liquids are spilled on the motor hou-
sing, immediately unplug the appliance and dry the motor housing to avoid risk of elec-
tric shock or fire. Do not attempt to operate the appliance, when liquids are on or in the
motor housing.
1. Always turn the appliance off, wait for the motor to stop completely, and unplug the
appliance from the power outlet before you start cleaning the motorblock.
2. Wipe the motor housing and power cord with a damp soft cloth. Take care not to
spill or drip water or any other liquids on the motor housing.
ATTENTION:
Ensure not to damage the drive gear. Never poke with anything into the
motorblock. If necessary use a soft brush for cleaning. If any liquids run into the motor-
block clean and dry the motorblock very carefully.
3. Thoroughly dry the motor housing after each cleaning or leave it dry naturally where
it is out of reach of young children. Afterwards assemble the appliance.
Attendance:
You do not need to oil the motor. Clean the parts only as described in
the instructions.
WARNING:
Return the entire appliance (including all parts and accessories) to an
authorised service centre for examination and repair.
