EN
EN
112
113
NOTE
When the motor is in operation or the pause function is active, you cannot chan-
ge the operating time. There will be no respond to the arrow keys. If you wish
to select another operating time, you need to cancel operation first (see below:
‘Cancelling Operation’).
USING THE PAUSE FUNCTION
During operation, at any time you like, you can activate the pause function. This will
turn off the motor and freeze the timer at the current point (see: ‘Properties of Your
New Stand Mixer / Pause Function’). Use this function for checking the mixing result
or adding additional ingredients without changing the current timer setting.
WARNING
–
Do not touch any moving parts (e.g. mixing drive, mincer
coupling, moved parts of the mincer), while the machine is connected to the
power supply.
For pushing down your food in the mixing bowl, use a soft spatula.
For changing the mixing tool, always cancel operation completely (press the con-
trol dial for approx. 2 seconds) and unplug the machine. Thereafter move the
mixing arm to the upper position (see: ‘After Usage’).
IMPORTANT -
When turning the control dial to zero with the pause function acti-
vated, the remaining operating time is deleted and the default value (20 minutes)
is shown again (see below: ‘Cancelling Operation’).
1. Shortly press the control dial for activating the pause function. Motor and timer
stop immediately.
2. If you wish to add further ingredients, in most cases you can use the feed ope-
ning in the splash guard. Cut large ingredients to smaller pieces.
3. For re-assuming operation, shortly press the control dial again. Motor and timer
continue running.
CANCELLING OPERATION
You may cancel operation at any time you like. This can be done in two ways:
• turning the control dial to zero or
• holding the control dial pressed for approx. 2 seconds until the signal sounds
and only dashes are displayed (see: ‘After Usage’).
NOTE
When moving the mixing arm to the upper position, the machine is switched off
automatically. However, in any case you should switch off the motor and unplug
the machine, before moving the mixing arm to the upper position.
NOTE
No matter, which way you choose for switching off the motor, the settings of the
speed and timer will be lost and the machine goes back to the defaults: speed
zero and operating time 20 minutes. If you wish to keep the set values, use the
pause function for stopping the motor (see above).
AFTER USAGE
WARNING
– While the machine is connected to the power supply, do not
hold your hands or any objects (e.g. cooking utensils or brushes) into the mixing bowl
or onto the moving parts (mixing drive, mixing tools, mincer coupling, worm shaft,
cross blade). Always switch off (press the control dial until the beep sounds) and
unplug the machine before touching moving parts of the machine or accessories and
before unlocking the mixing arm via the unlock button, and before disassembling any
accessories. Do not hold your hand into the joint for the mixing arm to avoid crushing
your hands. Do not grasp into the feed chute of the mincer or turn off the screw ring
of the mincer, while the mincer is installed at the mixing arm. Do not leave the machi-
ne unattended, when the machine is connected to the power supply.
NOTE
Ensure that the mixing arm is engaged in the upper position, when inserting or
removing the mixing bowl and/or mixing tools.
Always switch off and unplug the machine when the machine is not in use. Remove
all used accessories (see below: ‘Removing the Mixing Tool’ and ‘Removing and
Disassembling the Mincer’). Clean the machine and all used accessories (see: ‘Care
and Cleaning’). This is the best way of keeping your machine and the accessories
hygienically clean and ready for use.
SWITCHING OFF THE MACHINE
1. Press the control dial until the beep sounds (approx. 2 seconds) and only dashes
are shown on the display areas (standby mode).
