MG6000 Series Media Gateway User
’
s Manual
- 65 -
Modified configuration anyway ?'yes' or 'no'[yes]:yes
b). Display
IAD(8)#
show dsp
Counts of DSP: 2
Echo canceller: Enable
SCE: Disable
Input gain: -1dB
Output gain: -1dB
DTMF gain: -4dB
MAX FAX rate: 5 - 14400bps
Fax Mode: 0 -- T38
Redundancy for fax relay: 0
FAX code error correct: Disable
Use new RTP port in T38 fax: NO
DTMF transport mode: Transmit by Voice
Voice delay level: Middle
Ring Frequency:25Hz
Signal tone(0:standard 1:Chile): 0
5.1.6.3
RTP parameters
–
RTP start port
a). Configuration
IAD(8)#
set rtpstartport
-> Input RTP starting port(4000 - 13000)[13000]:13000
Attention
：
a). The Modified parameters of RTP will take effect after saving and reseting.
b). The RTP parameters is mainly used in the situation sensitive to the bandwidth, recommends using the
default parameters.
b). Display
IAD(8)#
show rtpstartport
RTP starting port 13000
5.1.6.4
RTP parameters
–
Frame counts, Max RTP packets in buffer, Configure Redundancy and
Correct remote RTP port
a). Configuration
IAD(8)#
set frame-buff
-> Frame counts in each TRP packet(1-5)[1]:1
-> Max RTP packets in buffer(1-300)[5]:5
-> Config Redundancy for RTP (0-5)[0]:0
