MG6000 Series Media Gateway User
’
s Manual
- 43 -
Fig 4-14 Route Parameter
All kinds of users could enter this page; all the users have the authorization to configure except common
users.
The parameter that had been modified will take effect after saving and resetting.
The Parameter shown as below:
l
FXO Call
At present, only the MG6002 (2) and MG6016 have the FXO port.
a). Use
‘
#
’
key to dial out when FXO virtual dial: when end of the simulate dial, add the
‘
#
’
key after the
number as the end flag.
b). PBX mode: which is sequential or polling.
c). Simulate hand up time: The time start to check the ring or hand up event.
d). Automatic virtual dial delay: After receive all digit of the number, FXO port waits some seconds and then
completes the simulate dial automatically.
e). Automatic virtual dial interval: the interval of each virtual dialing number.
f). DTMF Duration Time: The duration time of each virtual dialing number.
l
Network call
a). Network call failed process: when network call failed, there are three processes that are default, backup
register and register again.
b). WAN side channels number limit: the max count of communication channel, the default is the count of
the ports.
c). Network call timeout: is that after the IAD invite a session, the max time which wait for the response, if
timeout, the network call fail. The default value is 2000*10ms, and the range is 50*10ms~6000*10ms.
d). DTMF interval: the interval time of sent each DTMF, the default value is 1000*10ms.
4.2.9
Digit map configuration
Digit map is a form of routing configuration. It based on regular expression, and can configure several routes