MG6000 Series Media Gateway User
’
s Manual
- 28 -
User can preview the information of DHCP client on the page of
“
Device info
”
.
Attention
：
a). If DHCP client get IP address successfully, the
static IP of WAN port will be replaced by the dynamic
IP
address which the DHCP client get. If user wants to log in web management system, you need to type
the dynamic
IP that the DHCP client gets in IE.
b). After users start the DHCP, if the DHCP client is failed to communicate with the DHCP server, the IP
address can
’
t be received so that the device can
’
t be accessed through network. If that happened, users
have to forbid using the DHCP through the serial port, and configure fixed IP address and save the
configuration. You can use the new fixed IP address after reboot the device.
c). DHCP client and PPPoE client can
’
t be enabled at the same time.
l
PPPoE Client
After modifying the parameter of PPPoE Client
，
current configuration must be saved, and then reboot
the IAD.
IAD has built-in PPPoE client. It can dial into network after configuring ADSL user name, password,
server name (optional) and service name (optional) gotten from service providers. If the function of PPPoE
client is started, user can
’
t make a call through IAD until the PPPoE client dial into network successfully.
But user still can connect the IAD
’
s Ethernet port and modify the parameter of PPPoE Client through web
management system.
IAD dials to PPPoE during initiation. It will redial until dial successfully. Authorization error won
’
t lead
to redial. If the offline status is caused by line error, IAD will restart to dial again.
User can preview the information of PPPoE client on the page of
“
Device info
”
.
Attention:
a)
“
/
”
,
“
*
”
,
“
$
”
and space are invalid character and can not be input.
b) DHCP client and PPPoE client can
’
t be used at the same time
.
c) MG6032 could not support the function of PPPoE Client
.
4.2.3.2
Advanced Network configuration
Access
“
Network
”
->
“
Advanced config
”
. Enter the page of
“
Advanced Network configuration
”
. This page
includes the configuration about
DHCP Server
,
DNS Service
,
NTP Service,
STUN,
802.1X
,
and NAT Server.
The page of advanced network parameter configuration is shown as figure 4-6:
