User Manual Galileosky Base Block
24
Where:
ID - is a 29bit message identifier;
(8) - is the number of received bus bytes.
06 07 08 09 00 CC DD FF - is an 8byte message. (The lower byte is on the left, the higher
byte is on the right),
11bit identifiers are displayed as
ID=009 (8) 06 07 08 09 00 CC DD EE
Where:
ID - is an 11bit message identifier;
(8) - is the number of received bus bytes;
06 07 08 09 00 CC DD EE is an 8byte message. (The lower byte on the left, the higher byte
on the right).
3.
After all the identifiers have been displayed, you can see the CAN. End scan message.
To enable this mode:
1)
connect the tracking device to the vehicle CAN-interface;
2)
in the Configurator on Settings/CAN tab select bus rate and delay time (time of message
waiting time);
3)
press Start Scanning J1939. Received data are displayed in the right panel.
FMS Mode
This mode is activated in all tracking devices by default; it allows retrieving and decoding
messages relevant to FMS protocol:
total fuel consumption: the amount of fuel the vehicle had used since it was made;
tank fuel level: measured in percent. 0%-empty, 100%- full;
coolant temperature;
engine speed;
total mileage;
operating hours;
axis load.
ATTENTION!
Many car manufacturers support FMS protocol partially or do not support it at
all.
To enable this mode:
1)
connect the tracking device to the vehicle’s CAN-interface;
2)
give the CanRegime 2,250000,2000 command (section
CAN settings
) or select FMS
filter type in the Configurator on Settings/CAN tab;
3)
make sure that the device receives bus data and sends them to Device tab in the
Configurator;
