User Manual Galileosky Base Block
31
–
Color depth: 24bit;
–
Picture format: JPEG;
–
Picture resolution: 640x480 or 320x240 dots;
–
Picture size: 6-65kB;
–
Average picture size: 25kB;
–
Time of one picture receiving: 2-10 s;
–
Time of transmission to the server: more than 1 minute (depends on the picture size and
GSM connection quality).
The order of connection cameras via RS232 interface:
1.
The camera RXD, TXD, GND contacts should be connected to the device TXD, RXD, GND
contacts (section
Contacts description
).
ATTENTION!
The tracking device and the camera grounds should be connected! Camera has
a separate power supply.
2.
Insert a microSD card into the tracker slot.
3.
Make the right settings of RS232 device port for operation with camera, you can use
RS2320 or RS2321 command (section
Digital inputs settings
), or it can be done in the
Configurator on Settings\Digital inputs tab.
4.
Make sure that the tracking device operates with camera correctly, in the Configurator
give “makephoto 1” command and switching to the Troubleshooting tab tick RS232 and
RS232 detailed. When the tracking device receives a picture from the camera, there will
be “RS232[0].cam. rx pic” message displayed. Green LED on the camera blinks rarely in
standby mode and quickly during picture transfer.
5.
Evaluate the quality of the picture in the configurator or eject the microSD card from the
tracker and connect it to PC. Pictures from the camera connected to RS232 zero port are
saved in the catalogue Pic\RS0, to the first port – Pic\RS1. A separate catalogue is
created for each date, file names reflect the time when the shots were taken.
6.
Reinsert the microSD card.
The order of connection cameras via RS485 interface:
1.
Connect the RS485_A, RS485_B, GND camera contacts and the RS485_A, RS485_B,
GND device contacts correspondingly (section
Contacts description
).
ATTENTION!
The tracking device and the camera grounds should be connected!
Camera has separate power supply.
2.
Insert a microSD card into the device slot.
3.
Make the right settings of RS485 tracker port for operation with cameras and fuel level
sensors, use RS485FN 2 command (section
Digital inputs settings
) or the Configurator on
Settings\Digital inputs tab.
4.
Reset the tracking device.
5.
Make sure that the tracker operates correctly with the camera. For this, give the
“makephoto 2” command in the Configurator and, after switching to the Troubleshooting
tab, tick RS485. When the tracking device receives a picture from the camera, the
Troubleshooting will display RS485[0].cam. rx pic. message. Green LED on the camera
blinks rarely in standby mode and quickly during picture transfer.