User Manual Galileosky Base Block
16
In the same way it is possible to set zones of response and non-response for the tracking
device`s power supply voltage (POWINCFG command, section
Analog-discrete inputs
setting
). The state of discrete signal for input can be identified according to the 8
th
bit of the
“Status of the device” field.
Frequency count
To measure frequency in some sensors it is necessary to connect the sensor frequency output to
the sensor positive power supply via a 1kOhm resistor. Otherwise, frequency count is
impossible.
Determination of Strike and Incline
All devices can determine the device`s strike and incline.
To determine strike:
Install the tracking device so as one of the accelerometer axis looks vertically, it will
exclude false detections on road bumps;
Turn on strike and incline determination by SHOCK command (section
Track parameters
setting
). For example, if Z axis is vertical: SHOCK 3,90,5,1200.
A strike is an acceleration increase in horizontal plane; the correspondent bit is put in the Device
state field and strike coordinates are recorded.
To determine incline:
1.
Install the tracking device in a vehicle;
2.
By SHOCK command set maximum allowable incline angle and allowable time of this
angle exceeding. For example, a maximum angle is 20º, allowable exceed time is 5
seconds; SHOCK 3,20,5,1200.
On the tracker homing position change in a vehicle, SHOCK command should be given to
adopt the device to a new position.
X
Y
Z
Accelerometer axis
directions:
