G.Weike Laser
Profession Laser Manufacturer more than 15 Years.
25
Picture 4-13
Picture 4-14
4.4.3 Installation of ceramic part & nozzles
Picture 4-15
1. Put the ceramic part into the sensor component carefully, the locating pins
which on the sensor part should insert into the ceramic part.The nozzle should
put into the connecting ring by hand to avoid some damage if you use any tools.
In addition, make sure all the surface of these components is clean.
2. Tighten the connecting ring (Picture 4-15 “3”) with ceramic part (Picture 4-15
“2”) and set on the sensor part Picture 4-15 “1”).
3. Put the nozzle (Picture 4-15 “4”) into the ceramic part(Picture 4-15 “2”) by
hand.
4.4.4 Piping
1. Water Cooling System
Caution
:Make sure the laser source is off or the red dot is on
when install the nozzle.
