G.Weike Laser
Profession Laser Manufacturer more than 15 Years.
50
and steam.
5. Operators are not allowed to leave the post without permission to bring the
tube.
6. Fire extinguishers should be placed in readily accessible places; do not
process to turn off the laser; not in the absence of a protective laser beam
placed near the paper, cloth or other flammable materials.
7. Abnormal in the processing process, should immediately press the
emergency stop button, timely troubleshooting or reported to the competent
personnel.
8. Keep the laser, bed and ground clean, orderly, no oil, workpiece, sheet
metal, waste piled up according to the provisions.
9. Use gas cylinders should be avoided when crushing wire so as to avoid
leakage accident. Use of gas cylinders, transport should be monitoring
procedures to comply with cylinders. Prohibit the cylinders in the sun
prolonged sun exposure or near sources of heat. When the botle valve is
open, the operator must be standing on the side of the bottle mouth.
10. Before open the power supply of water cooling machine, should check the
water level of water cooling machine is strictly prohibited anhydrous or the
water level is too low when open water machine, water cooling equipment to
avoid damage. Around the water cooling machine on both sides and the top
should allow sufficient space, prevent the fan blowing hot air into the inlet,
water cooling machine. Cooler inlet and outlet pipe is strictly prohibited
squeeze, stampede and keep the waterways.
11. Open the laser power supply must first before the water cooler, water
cooler is stable to laser range can start the laser.
12. In the working process of the equipment, operation personnel should be
hand operating handle (prohibited equipment work process, the handle is
placed on one side) in order to in case of an emergency operator immediately
press the pause or stop button. In order to operating device and causing
unnecessary harm.
13. Prior to the start of processing, the work should be determined in the
scope of the work piece of the plate in the plate. To prevent the start button in
the press after the laser head to move to the plate outside the Z axis, the laser
head hit the knife, causing damage to the head of the laser.
14. The product produced by the laser wavelength of 1064nm, radiation to the
human body skin will cause burns, long time to look at the laser beam will
cause serious damage to the eyes of the retina (such as cataract), the operator
must wear 1064nm eye protection.
15. A large amount of smoke and dust will be generated when the equipment
is cutting some plate, and the air outlet pipe of the fan should be induced to the
outside, and the operator should wear a dust mask to prevent the occurrence
of occupational diseases.
16. Laser cable is strictly prohibited to bend, so as to avoid the cable inside
the glass fiber broken, cable exposed parts should be installed to protect the
cover plate to prevent the step.
