G.Weike Laser
Profession Laser Manufacturer more than 15 Years.
9
stainless steel, alloy steel and aluminum alloy. User should choose different
cutting gas according to different materials. In the cutting gas system, due to
installed pressure sensor inside, make sure that machine stop work in time
when gas pressure is not enough, avoid the abandonment of cutting parts.
The air pressure threshold can be regulated by the upper pressure sensor
screw set, cut with compressed air and oxygen can also be adjusted by
controlled proportional valve.
2.6.2 Water system
Water chiller of fiber cutting machine’s water system adopts double
temperature water chiller, one is cooling laser and the other is cooling cutting
head.
Note
: In order to guarantee normal running of the whole machine and laser,
maintain the stability of laser power and laser mode is good, equipment and
auxiliary means is extremely important. If the user is unauthorized use that not
meets requirements of the machine’s water, electricity, gas caused low laser
power, bad laser mode and other parts of damage, are not within the scope of
the warranty
