Fujitsu PRIMERGY RX300 S7, Upgrade And Maintenance Manual

Page: 158 / 560

158 Upgrade and Maintenance Manual
RX300 S7
Hard disk drives / solid state drives
●
Under no circumstances should you remove an HDD / SSD module
while the system is in operation if you are not sure that the drive is
operated by a RAID controller and belongs to a disk array that is
operating in RAID level 0, 1, 1E, 10, 5, 50, 6 or 60.
An HDD / SSD module can only be replaced during operation in
conjunction with a corresponding RAID configuration.
●
All HDD / SSD modules (drives) must be uniquely identified so that
they can be reinstalled in their original mounting locations later. If this
is not done, existing data can be lost.
7.3.4.1 Required tools
●
Preliminary and concluding steps: tool-less
●
Replacing a 2.5-inch HDD / SSD module: tool-less
7.3.4.2 Preliminary steps
Perform the following procedures:
Ê
"Opening the rack door" on page 64
Ê
"Locating the defective server" on page 56
Ê
Locate the defective HDD / SSD module as described in section "Local
diagnostic indicators on the front" on page 60 .
Only applicable for removing intact HDD / SSD modules:
Ê
Before removing a non-defective HDD / SSD module, put the drive into
"Offline" mode using your RAID configuration software.
7.3.4.3 Removing a 2.5-inch HDD / SSD module
Ê
Remove the HDD / SSD module to be replaced from the server as described
in section
"Removing a 2.5-inch HDD / SSD module" on page 155 .
7.3.4.4 Installing a 2.5-inch HDD / SSD module
Ê
Install the new HDD / SSD module into the empty drive bay as described in
section
"Installing 2.5-inch HDD / SSD modules" on page 151