Fujitsu PRIMERGY RX100 S8, Upgrade And Maintenance Manual, Page: 84 / 296

84 Upgrade and Maintenance Manual
RX100 S8
Basic software procedures
Ê
For the changes to take effect, you need to reboot the network by entering
the following command:
# service network restart
I
If the system board or network controller offers multiple LAN ports, it is
necessary to update the remaining
ifcfg-eth<x> definition files
accordingly.
Ê
Update the NIC configuration file to reflect the new card sequence and MAC
address.
5.2.13 Enabling BitLocker functionality
If BitLocker Drive Encryption has been disabled for maintenance purposes (see
section
"Disabling BitLocker functionality" on page 63 ), it has to be re-enabled
to complete the service task.
I
If BitLocker Drive Encryption has been disabled prior to replacing
components you won't be asked for a recovery key when rebooting the
server after the maintenance task. However, if BitLocker functionality has
not been disabled, Windows will enter recovery mode and ask you to
input recovery key for further booting.
Ê
In this case, ask the system administrator to enter the recovery key in
order to boot the operating system.
Ê
Ask the system administrator to enable BitLocker-protection on the
operating system drive, using the BitLocker setup wizard available either
from the Control Panel or Windows Explorer.
Ê
Open Bitlocker Drive Encryption by clicking the Start button, clicking
Control Panel
, clicking
Security
, and then clicking
Bitlocker Drive
Encryption
.
I
Administrator permission required: If you are prompted for an
administrator password or confirmation, type the password or
provide confirmation.
Ê
To enable a temporarily disabled BitLocker, click
Turn On BitLocker
.
Ê
Follow the instructions in the BitLocker Setup wizard.
I
For further information on how to enable BitLocker drive encryption,
please refer to the Microsoft Knowledge Base.
Fujitsu service partners will find additional information (also available in
Japanese) on the Fujitsu Extranet web pages.