Fujitsu PRIMERGY RX100 S8, Upgrade And Maintenance Manual, Page: 124 / 296

124 Upgrade and Maintenance Manual
RX100 S8
Hard disk drives / solid state drives
7.2.8 Replacing the 4 x 2.5-inch HDD backplane
7.2.8.1 Preliminary steps
Ê
"Locating the defective server" on page 43
Ê
"Shutting down the server" on page 45
Ê
"Disconnecting the server from the mains" on page 46
Ê
"Getting access to the component" on page 47
Ê
Release all HDD/SSD modules and pull them out a few centimeters, see
section
"Removing 2.5-inch HDD/SSD modules" on page 120
I
The HDD/SSD modules need not to be removed. But if you want to
remove them nevertheless, check if all HDD/SSD modules are
uniquely identified so that you can reinsert them into their original
bays.
7.2.8.2 Removing the defective 4 x 2.5-inch HDD backplane
I
For configurations with up to four 2.5-inch HDDs/SSDs, please refer to:
section
"Left side 4 x 2.5-inch HDD backplane (A3C40157852)" on
page 125 .
For configurations with up to eight 2.5-inch HDDs/SSDs, please refer to:
section
"Left side 4 x 2.5-inch HDD backplane (A3C40157852)" on
page 125 or "Right side 4 x 2.5-inch HDD backplane (A3C40157828)" on
page 126 .
Field Replaceable Unit
(FRU) Hardware: 10 minutes
Tools: tool-less